Dimplex CDFI1000-PRO Owner's Manual page 12

Installation
4. Initialize the tethered controller
to the remote (see operation
section, page 16).
5. Fill the unit:
• Refill Containers - remove
the fill cap assemblies from
the inlet to the reservoir tanks,
then install the refill containers.
(
Figure 10, page 18
!
NOTE: During initial
installation, the Refill Container
should be refilled after the
Reservoir has filled to ensure
the maximum operating time.
Refill Container holds 42 oz.
(1.25L).
• Hard Plumbed - prime each of
the water reservoirs with 33.5 oz
(1L) of water.
!
NOTE: Normal tap water can
be used in the Opti-myst
as the tap water is not considered
to be hard water. In the event your
tap water is hard, you may use
softened water or distilled water
with ⅛ tsp. of salt (0.5 mL) added
to the water reservoir. (The use
of additional salt should only be
when you notice that the unit is not
producing mist as expected.)
6. Install the media plate or logset
accessory on top.
!
NOTE: If the intention is to
accessorize the unit with something
12
)
as long
®
other than just the media plate or
logset, ensure that media used
does not have the ability to create
small particles that may fall into the
unit or have a overall weight above
10 lbs (4.5 kg) for the CDFI500-
PRO and 20 lbs (9 kg) for the
CDFI1000-PRO.
Customize Flame
The CDFI500-PRO and
CDFI1000-PRO come with inserts
that allow you to customize the
look of the flame. Refer to Figures
5 and 6. To use the spacers, first
break them along the break line
(Figure 5). Second, insert into the
nozzle at desired locations. It is
recommended to place them under
any media that crosses through the
flame, for example, logs.
To use the slots, insert them into
the nozzle (Figure 6). A total of
3 slot inserts can be used in each
nozzle.
Figure 5
www.dimplex.com