Table of Contents
Advertisement
Serial Control
The CS724KM's built-in bi-directional RS-232 serial interface allows system
control through a high-end controller or PC. This control feature can be
accessed via HyperTerminal connection through a computer connected to the
CS724KM.
Console Login - HyperTerminal
Once a physical connection from the computer to the CS724KM has been made
and the Station Switch on the front panel is set to the S position (see Station
Switch, page 4), you can establish a HyperTerminal session using the
instructions below.
1. Open the HyperTerminal application, and configure the port settings for
the appropriate COM port number, then click OK.
Bits per Second: 19200, Data Bits: 8, Parity: None, Stop bits: 1, Flow Control:
None.
2. The Set Baud Rate command allows you to set the baud rate of the
computers connected to the CS724KM's ports. Use the Formula - to set
Parameters - to create a Command.
RS-232 Commands
(Continues on next page.)
Chapter 7
41
Advertisement
Table of Contents
