Table of Contents
Advertisement
Item
File
Settings
Status List
Chapter 5. Boundless Switching Utility
Click to open the File menu:
New: clears all Displays allowing you to create a new
layout.
Load File: opens a browse window to select and load
a previously created Layout (*.KM) file.
Save as: opens a browse window to save the current
layout (*.KM) file.
Quit: closes the Boundless Switching Configuration
Utility.
Click to open the Settings menu:
Mouse Acceleration: sets the rate at which the cur-
sor speed increases as the speed of the cursor moves
faster across the display.
Mouse Position: Sets the default cursors position for
when you switch from one computer to another. When
the mouse cursor leaves to switch to another com-
puter, the cursor on the previous computer will auto-
matically move to this position on the monitor.
Click the Add icon over empty blocks to add a new
display. After adding a display you are prompted to enter
the screen resolution of the display. It is important that
the resolution setting is correct (see Resolution, below).
After setting the resolution a Display icon appears. Add
icons to match the physical monitor setup of your
installation.
The Display icon defines the position of a display in the
layout and allows you to configure the port. Use the
drop-down menu to select the port.
If your installation has one CS724KM, only Primary ports
(P1, P2, P3, P4, or no port) should be used. When two
CS724KM's are installed (refer to page 10), computers
connected to the First Stage unit use Primary ports (P1,
P2, P3, P4, or no port), and computers connected to the
Second Stage unit use the Secondary ports (S1, S2,
S3, S4, or no port).
X
Click the
to delete the Display icon.
The Status List provides an easy way to select and
configure displays connected to each port. Click a port
(1~4) on either the Primary or Secondary switch to
highlight the connected Display in the main panel.
Description
33
Advertisement
Table of Contents
