Table of Contents
Advertisement
22. DO NOT touch live electrical components or parts.
23. Turn off power before checking, cleaning, or replacing any parts.
24. Be sure all equipment is properly installed and grounded according to national, state, and
local codes.
25. Keep all cords dry, free from grease and oil, and protected from sparks and hot metal.
26. Inspect power and control cables periodically. Replace if damaged or bare wires are
exposed. Bare wiring can kill!
27. DO NOT bypass or defeat any safety interlock systems.
28. Always check that the work piece is securely clamped and that long pieces are properly
supported.
29. DO NOT use a saw blade size that is outside the limits of the machines specifications.
30. Immediately release the start / run trigger button if the saw blade should get stuck in a cut.
Press the red power off switch and remove the yellow lock key before raising the machine
head. Then open the vise and remove the work piece. Check the blade teeth for damage. If
any of the teeth are broken or missing replace the saw blade.
31. The operator should stand in front of the machine using a single
hand to grip the feed handle.
32. A proper break-in period for the cold saw is recommended.
Intervals of 30 minutes to be repeated two or three times, after
which the cold saw may be used continuously.
8
8
Advertisement
Table of Contents
