Selecting The Digipeater Route; My Call Sign Setting; Filter Setting For Messages Received - Yaesu FTM-100DR Instruction Manual
C4fm/fm 144/430 mhz dual band transceiver
Hide thumbs
Also See for FTM-100DR:
- Operating manual (177 pages) ,
- Instruction manual (82 pages) ,
- Update instruction manual (13 pages)
Table of Contents
Advertisement
Tip
The settings, "2 INTERVAL", "3 PROPORTIONAL", "4 DECAY", "5 LOW SPEED", and "6 RATE
LIMIT"are all disabled while SmartBeaconing is operating.
Selecting the digipeater route
This selects the call sign and ALIAS of the digipeater used.
Please refer to "Setting the digipeater route" (
My call sign setting
This registers your own station call sign that is required for APRS communications.
APRS data cannot be sent when your own station call sign is not registered. Please
make sure to register your own station call sign.
Refer to "Setting your own station call sign" (
Filter setting for messages received
The group filter for receiving messages and bulletin messages from specific groups
(ALL, CQ, QST, YAESU etc.) can be set.
A maximum of up to 9 characters can be entered.
"1 GROUP 1 ALL", "2 GROUP 2 CQ", "3 GROUP 3 QST", "4 GROUP 4 YAESU", "5
GROUP 5 (any)" and "6 GROUP 6 (any)" can be set for the group code.
For bulletin, "7 BULLETIN 1" to "9 BULLETIN 3" can be set.
1
Press
for one second or longer.
The set-up menu will be displayed.
2
Turn the DIAL, select [10 APRS], then press
The menu list will be displayed.
3
Turn the DIAL, select [17 MESSAGE GROUP], then
press
.
The message group list will be displayed.
4
Turn the DIAL to select a saved group number, then
press
.
The character input screen will be displayed.
5
Turn the DIAL, select characters, then press
Tip
You can enter capital letters, numbers, and a certain symbol (only "∗" can be used).
Press
Press
Press
[
Press
[
Press
Please refer to "Input characters" (
[
] → This switches between letters, numbers, and ∗.
[
] → This deletes all characters to the right of the cursor.
] → This shifts the cursor to the left.
] → The cursor will shift to the right.
[
] → This deletes all characters to the left of the cursor.
Using the APRS set-up menu
P.41) for the details.
P.6) for the details.
.
.
P. 20) in the basic operating manual for details.
70
Advertisement
Table of Contents
