Crestron B-G1-WPK Installation Manual

Water Resistant Cover Kit for Single
Gang Wall Panel: B-G1-WPK
The Crestron water resistant cover kit is specifically designed for 'CNX-B Series' single gang
wall panels. There are four urethane covers per kit. When properly installed the cover
prevents liquids and other air-born materials from settling directly onto the panel, but does not
interfere with regular usage of the unit.
No tools are required to install the B-G1-WPK cover; a silicone rubber adhesive is provided.
The panel must be properly setup (i.e., connected to the network) as outlined in the latest
version of the Single Gang Keypads Operations & Installation Guide (Doc. 8173) prior to
installing the water resistant cover. Complete the steps listed adjacent to the diagram for
installation.
MOUNTING
SURFACE
WARNING: Silicone rubber adhesive is an irritant to skin, eyes, and respiratory tract. Skin and eye
protection required. Avoid repeated or prolonged contact. Good ventilation is required.
WARNING: To avoid shock hazard and possible damage to the unit, never install a touchpanel where it
may be exposed to rain or very high humidity. This kit is designed to resist water (eg. protect unit from
wet hands) and in no way provides waterproof protection.
Further Inquiries
If after reviewing this sheet for the B-G1-WPK, you still have questions, please take
advantage of Crestron's award winning customer service team by calling:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7576
B-G1-WPK
COVER
GAP LOCATION
•
In the US and Canada, call Crestron's corporate headquarters at 1-888-CRESTRON
[1-888-273-7876].
•
In Europe, call Crestron International at +32-15-50-99-50.
•
In Asia, call Crestron Asia at +852-2341-2016.
•
In Latin America, call Crestron Latin America at +5255-5093-2160.
•
In Australia and New Zealand, call Crestron Pacific at +613-9480-2999.
Water Resistant Cover Kit for Single Gang Wall Panel: B-G1-WPK
INSTALLED PANEL
Specifications subject to change without notice.
1. Remove the backing
from the tape that
surrounds the perimeter
of the cover.
2. Place the cover over the
panel making sure that
the gap in the tape
perimeter is located at
the bottom.
3. Firmly press down the
cover so that it
completely encloses the
panel.
4. Except for the gap at the
bottom, apply a bead of
silicone rubber adhesive
around the outer edge of
the cover (form a seal
with the mounting
surface).
5. Do not use the panel
while the adhesive cures
(typically 24 hours).
DOC. 6100
www.crestron.com
01.03