How To Use The Operation Panel; Preface - JUKI APW-895NE Instruction Manual

VI. HOW TO USE THE OPERATION PANEL

1. PREFACE

1) How to use the data (EPD data) for a certain unit of the APW-895NE for other unit of the APW-
895NE
To use the EPD data on the APW-895NE, read the data into the IP-420.
Insert the relevant medium into the IP-420. Select pattern number xxx from EPD data.
2) Folder structure of the media
Store each file in the directories below of the media.
Media drive
Data that are not stored in the directories above cannot be read. So, be careful.
3) CompactFlash (TM)
■ Inserting the CompactFlash (TM)
1. When the inserting direction is wrong, panel or media may be damaged.
2. Do not insert any item other than the CompactFlash (TM).
3. The media slot in the IP-420 accommodates to the CompactFlash (TM) of 2 GB or less.
4. The media slot in the IP-420 supports the FAT16 which is the format of the CompactFlash (TM).
FAT32 is not supported.
5. Be sure to use the CompactFlash (TM) which is formatted with IP-420. For the formatting proce-
dure of the CompactFlash (TM), see "VI-16. PERFORMING FORMATTING OF THE MEDIA" p. 90.
APW-895NE
1) Turn the label side of the CompactFlash(TM) to
this side (place the notch of the edge to the rear.
) and insert the part that has a small hole into
the panel.
2) After completion of setting of the media, close
the cover. By closing the cover, it is possible to
access. If the media and the cover come in con-
tact with each other and the cover is not closed,
check the following matters.
• Check that the media is securely pressed
until it goes no further.
• Check that the inserting direction of the me-
Media
dia is proper.
− 22 −
APW××× .EPD
APW××× .EPD
APW××× .EPD