Initial Setting - Mitsubishi Electric AG-150A-A Installation Manual

8 Initial Setting

NOTES
* Choose from two initial setting methods: 1) Making the settings via AG-150A, 2) Making the setting via the LAN using the Initial
Setting Web.
• This manual provides the instructions on making the initial settings from AG-150A.
• Please refer to AG-150A Instruction Book or the Instruction Book that are provided with Initial Setting Web.
• Refer to the PAC-YG50ECA Expansion controller Installation/Instructions Manual for how to connect Expansion controllers.
System 1: Standard configuration (system with 50 units of equipments or less)
System 2: System with connection to one or more Expansion controllers (system with more than 50 units or equipments)
The startup procedures vary with system configuration.
The following table summarizes the initial setting procedures.
Initial setting procedures
1. Startup
2. Clock setting
3. Unit information settings
4. Network settings
5. Group settings
6. Miscellaneous settings
7. Clock setting
8. Exiting the Initial Settings
window
System configuration
1 2
1 Check that the version of the AG-150A software is 2.10 or later.
Check that the DB No. of the AG-150A and the PAC-YG50ECA to be
connected match.
2 Set the IP address for the Expansion controller with the dipswitch on
PAC-YG50ECA.
1 3 Turn on the power supply unit (PAC-SC51KUA) to start up the AG-150A.
(Turn on the Expansion controllers as well for System 2.)
2 4 The display language selection window will appear. Select the desired
language by touching the language.
3 5 The Initial Setting screen will appear.
(Once the initial settings have been made, the monitor screen will
appear when the unit is turned on. Touch the
the screen to bring up the Initial Settings window if necessary.)
1 Touch "Date and time" on the Initial Settings window.
2 Change other settings as necessary by touching the desired items, and
touch "Save Settings" to save the changes.
1 1 Touch "Unit Info." on the Initial Settings window.
2 Set the Expansion Controller setting to "Do not use".
2 Set the Expansion Controller setting to "Use".
3 3 Change other settings as necessary by touching the desired items, and
touch "Save Settings" to save the changes.
1 1 Touch "Network" on the Initial Settings window.
2 Check that the AG-150A tab is selected.
3 Touch the EC tabs, and make necessary settings for the EC-1 through
EC-3.
2 4 Change other settings as necessary by touching the desired items, and
touch "Save Settings" to save the changes.
1 1 Touch "Groups" on the Initial Settings window.
2 Touch the EC tabs, and make necessary settings for the EC-1 through
EC-3.
2 3 Change other settings as necessary by touching the desired items, and
touch "Save Settings" to save the changes.
1 1 After completing the group setting, make the settings for other items as
necessary by touching the item on the menu to be set.
• Interlocked operation setting (interlocked operation between
• Refrigerant system monitor (monitoring of refrigerant piping
• Block settings
• Floor layout settings
• User settings
1 1 Touch "Date and time" on the Initial Settings window.
2 2 Change other settings as necessary by touching the desired items, and
touch "Save Settings" to save the changes.
1 1 When all settings have been completed, touch the
the Monitor/Operation window.
LOSSNAY and indoor units)
connection between indoor and outdoor units)
- 23 -
icon at the top right of
icon to return to