Mitsubishi Electric AG-150A-A Installation Manual page 21

7 Screw down the A type installation plate (supplied) on the
control board door with the M4 flathead screws (supplied).
Drill four screw holes and a 278 mm [W] × 152 mm [H] hole
on the control board door ahead of time.
(Cut screw threads in the control board screw holes, or use
nuts to tighten screws.
Use the B type installation plate (supplied) if the above is not
feasible.
Refer to section 2-14.)
8 Remove the AG-150A surface cover.
9 Install the AG-150A on the A type installation plate with the
M4 roundhead screws (supplied).
0 Replace the AG-150A surface cover.
a Connect the power supply unit and centralized controller.
NOTE
* When using an LAN and external signal
I/O, refer to section
11 External input/output usage .
A-type installation
plate (supplied)
M4 flathead screw
(supplied)
M4 roundhead screw
(supplied)
- 20 -
φ
4 or above
15
278 (10- / )
16
7
200 (7- / )
8
Control board
Unit: mm (in)