Table of Contents
Advertisement
7.5 Installing work holding
The faceplate is used for tuning bowls. There are a number
of holes for mounting the workpiece. Thread the faceplate
onto the spindle in a clockwise direction, and tighten two
setscrews (E, Fig 30).
Remove the faceplate by loosening two set screws. Push in
the spindle lock and use the provided wrench on faceplate
flats.
7.6 Adjusting tool rest
A 300mm tool rest is provided with your lathe. It is designed
to allow adjustment for height and position.
Loosen locking handle on tool rest base (G, Fig 31) to slide
base forward or back, and to angle it to the bed. Tighten
locking handle firmly before operating lathe.
Loosen handle (H) to raise or lower tool rest and angle it to
the work. Tighten handle before operating lathe.
Tool rest extension:
The extension (J, Fig 32) mounts to the tool rest base and
offers greater reach for the tool rest when turning off the bed
using the headstock at an angle, as shown.
Make sure the clamp bushings (K) are pulled apart sufficiently
to accept the post of the extension.
Fig 30
Fig 31
7.7 Adjusting tailstock
Turn the hand wheel (R, Fig 33) clockwise to move tailstock
spindle forward. Lock tailstock spindle with the indexable
knob (Q).
The handle (P) locks the tailstock in position on the bed.
The live centre (S) can be ejected by turning the hand wheel
counter-clockwise.
The live centre pin can be removed to allow deep hole drilling
operations.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be
carried out after the machine is protected against
accidental starting by pulling the mains plug.
Clean the machine regularly.
Inspect the proper function of the dust collection daily.
Defective safety devices must be replaces immediately.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
Fig 32
Fig 33
Advertisement
Table of Contents
