Table of Contents
Advertisement
Position the tool rest as close to the workpiece as possible.
Tighten locking handles.
For turning between centres the tool rest is set approximately
3mm higher than centre line (Fig 20, 21 and 22.
Fig 20
Fig 21
Fig 22
6.5 Bowl turning
Turn outside of bowl between centres.
Turn a short tenon the size of the hole in the faceplate
(T, Fig 23). This will allow centring the workpiece.
Fig 23
Mount the workpiece (A, Fig 24) directly to the face plate
using 4 wood screws (C) from the back. Be careful to use
screws short enough not to interfere with the cutting process
but long enough to hold the workpiece securely to the face
plate.
Fig 24
If screw mounting is not allowed at all, the work may be glued
to a backing block (D) and the backing block screwed to the
face plate. A piece of paper in the glue joint will prevent
damaging the wood when separated later.
Mount the face plate with the workpiece already attached
onto the spindle nose thread and hand tighten.
If reversing spindle rotation, make sure face plate, chuck or
other work holding is secured with the set screws, to avoid
threading loose.
Move tailstock away, remove centre from tailstock to prevent
injury.
Turn the workpiece by hand to see if it rests securely and can
be rotated freely.
Position the tool rest as close to the workpiece as possible.
Tighten locking handles.
For face plate turning the tool rest is set slightly lower than
centre line.
Caution:
Cut with your chisel on the left side of the turning centre only.
Use left hand to control cutting edge of gouge, while right
hand swings tool handle around toward your body (Fig 25).
Fig 25
Advertisement
Table of Contents
