Decommissioning; Removing Cables; Dismantling The Embedded Pc - Beckhoff CX20 0 Series Manual

Decommissioning

12 Decommissioning
12.1

Removing cables

Electrical voltage
If the power supply is switched on during dismounting, this can lead to damage to the Embedded PCs.
Switch off the power supply for the Embedded PCs during dismounting.
Before dismantling the Embedded PC, shut down the Embedded PC and switch off the power supply. Only
then can you remove all the cables. Also remove all cables from the first terminal after the power supply
terminal.
Requirements:
• Terminate your software and shut down the Embedded PC.
• Switch off the power supply.
Remove the cables as follows:
1. Remove the wiring from the basic CPU module, any system interfaces that may be connected and the
extension modules.
2. Remove the wiring from the first terminal next to the power supply terminal.
3. Pull the orange strap to remove the first terminal after the power supply terminal by pulling it forward.
ð In the next step the Embedded PC can be removed from the DIN rail and dismantled.
12.2

Dismantling the Embedded PC

The CX2000 Embedded PC series is a modular system and enables individual modules to be replaced or
removed quite easily. This section describes how to remove devices from the CX2000 Embedded PC series.
80
NOTE
Version: 2.5 CX20x0