Testing - D.T.Systems CDT 1000 PLUS Owner's Manual

NOTE: Before testing, make sure that both units are fully
charged and the power to the Collar Receiver is "ON".
To Test the Electronic Stimulation:
A) Place the tester firmly on the
contacts of the Collar Receiver.
B) Set the intensity (note - an intensity
level setting of 4 or less might not be
enough to light the tester).
C) Push the 'NICK' or 'CONT' button.
D) The tester light will quickly flash once when the
Nick button is pushed and light repeatedly when the
Continuous Stimulation button is pushed (the test
light will be brighter at higher intensity levels).
A) Press the button on the left side of the transmitter
(Vibrate button) and the collar unit will vibrate only.
B) Press the button on the right side of the transmitter
(Vib.+Stim. Button) and the unit will vibrate only for
1/2 a second. The tester will then light while vi-
brating at the same time.
If the collar unit is not responding to any signals
NOTE:
from the transmitter, the collar may need to be repro-
grammed to the transmitter (see page 13).

TESTING

To Test the Vibration:
(CDT 2000 PLUS only)
12