Lexmark MB2442 User Manual page 200

Troubleshooting
Action
Step 5
a
Remove the toner cartridge, and then remove the imaging unit.
Warning—Potential Damage: Do not expose the imaging unit
to direct light for more than 10 minutes. Extended exposure
to light can cause print quality problems.
Warning—Potential Damage: Do not touch the
photoconductor drum under the imaging unit. Doing so may
affect the quality of future print jobs.
b
Push either side of the transfer roller, located below the imaging
unit, to check if it depresses and bounces back into place.
CAUTION—HOT SURFACE: The inside of the printer
might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
c
If the transfer roller does not depress and bounce back into
place, then remove and insert it.
1
Pull up one end of the transfer roller and push it down until
it clicks into place.
2
If necessary, repeat the step on the other end.
d
Firmly shake the imaging unit to redistribute the toner, and then
insert it.
e
Insert the toner cartridge.
f
Turn off the printer, wait for 10 seconds, and then turn on the
printer.
g
Print the document.
Is the print light?
Step 6
a
If the issue happens after installing a new maintenance kit, then
check whether the transfer roller included with the kit is
installed.
Note: If necessary, replace the transfer roller.
b
Print the document.
Is the print light?
Step 7
Check the status of the imaging unit. From the control panel,
navigate to:
Status/Supplies > Supplies
Is the imaging unit near End of Life?
Yes No
Go to step 6. The problem is
solved.
Go to step 7. The problem is
solved.
Go to step 8. Contact
support.
200
customer