Table of Contents
Advertisement
TouchPad click board
Description
TouchPad click board
TouchPad click board cable
TouchPad cable
Before removing the TouchPad click board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
To remove the TouchPad click board:
1.
Disconnect the TouchPad cable from the TouchPad board (1) and the system board cable from the
TouchPad click board (2).
2.
Remove the three Phillips PM2.0×4.0 screws (3) that secure the TouchPad click board to the computer.
3.
Remove the board from the computer (4).
Reverse this procedure to install the TouchPad click board.
54
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
32).
Optical drive on page
Bottom cover on page
33).
41).
Spare part number
926530-001
928882-001
926518-001
Advertisement
Table of Contents
