General Safety Instructions - GW Instek GCP-300 Instruction Manual

General Safety Instructions:

Read the following safety instructions to avoid injury and prevent damage
to this product or any products connected to it. Use this product only as
specified.
Only qualified personnel should perform service procedures.
To Avoid Fire or Personal Injury
Connect and Disconnect Properly.
Connect the probe output to the
measurement instrument before connecting the probe to the circuit under
test. Disconnect the probe input and the probe ground from the circuit under
test before disconnecting the probe from the measurement instrument.
Observe All Terminal Ratings.
To avoid fire or shock hazard, observe
all rating and markings on the product. Consult the instruction manual for
further ratings information before making connections to the product.
Replace Batteries Properly.
Replace batteries only with the proper type
and rating specified.
Do Not Operate Without Covers.
Do not operate this product without
the covers or panels.
Avoid Exposed Circuitry.
Do not touch exposed connections and
components when power is present.
Do Not Operate With Suspected Failures.
If you suspect there is
damage to this product, have it inspected by qualified service personnel.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
3