Holding the Display
4.2 Holding the Display
This section describes how to hold measured values and phase
detection results shown on the display. The hold function can be
used on the Voltage Measurement screen, Phase Detection screen,
and Frequency Measurement screen.
Enabling and disabling the hold function
When normal phase is detected and when the instrument is
unable to detect the phase, the yellow-green backlight will turn
on. When reversed phase is detected, the red backlight will turn
on.
42
HOLD
Press
to select whether to
enable or disable the hold function.
[HOLD]
When
normal operation):
The hold function is disabled.
When
[HOLD]
The hold function is enabled.
(Measured values and detection
results will be held.)
is not shown (during
is shown: