Settings; Angle - Nikon NPL-322 Instruction Manual

5 Menu Key

Settings

To display the Settings menu, press
Settings
Use this menu to configure the initial job settings.
Some job settings, specified in the following sections, cannot be changed
once a job is created. If any of these settings are changed while a job is open,
a confirmation screen appears, asking you to create a new job with the new
settings, or to work with those settings without recording any data. For more
information, see Settings, page

Angle

To open the Angle menu, press
the Settings menu.
VA zero
The VA zero job setting cannot be changed once a job is created.
Resolution
HA
The HA job setting cannot be changed once a job is created.
When this field is set to Azimuth, the horizontal angle (HA) that appears and recorded is in Azimuth value. When
this field is set to 0 to BS, HA is in HA zero to BS value.
114 Total Station NPL-322 Instruction Manual
on the MENU screen.
180.
[1]
Zenith/Horizon/Compass
1"/5"/10" or 0.2 mgon/1 mgon/2 mgon
0 to BS/Azimuth
or select
[2]
or select in
Angle