Short Parts List - gledhill Torrent GreenHeat OV TGH140 Design, Installation & Servicing Instructions

SERVICING AND MAINTENANCE
Description
1 PHE pump Grundfos, UPR 15-50
SWEP, 24 Plate heat exchanger (All non heat pump
2 Plate heat exchanger (PHE)
models)
SWEP, 30 Plate heat exchanger (Heat pump models
3 Plate heat exchanger (PHE)
only)
4 Pump isolating valve - outlet 22mm
5 Pump isolating valve - inlet 28mm
6 Top immersion heater
Shell, 14" Immersion heater - with stat
7
Bottom immersion heater
8 Main PCB controller Argus Vision 147/4GS controller
9 Middle sensor Tasseron, Single sensor
10 DHW inlet & outlet sensors Tasseron, single sensor complete with nut & olive
11
Ballvalve 1212 Part 2
12 Ballvalve Float
Single Shot Overheat Immersion
13
Stat
14 Plastic Feed and Expansion Tank
15
22mm Blank
16 28mm Blank
17 Limit Thermostat
18 Non Return Valve
19 Manual Reset Overheat Thermostat
20 F&E For Solid Fuel (Kit)
21 Scale Inhibitor

SHORT PARTS LIST

Supplier & Model Part Number Stock Code
5950543
E8T/24
E8T/30
7308123
Incalloy 825
147/4GS
TSK10B4
Wet pocket
sensor, comes
as a kit.
Page 44
Water Savings
Water Related Costs Can Be Reduced By Good Plumbing Practice
GT089
GT017
GT528
XB121
XB122
XB482
XB103
GT198
GT198
FT206
FT429
XB114
XB343
FT311
FT466
XC010
GT048
XC011
EX015
XB142
Vast quantities of water are needlessly run o to waste due to Taps, Mixers and Showers
discharging ow rates far in excess of the rates required for them to perform their duties.
The contrasting ow rates shown on this lea et clearly illustrate the savings that can
be made whilst still providing a good performance.
British made Aqua ow Regulators provide constant ow rates by automatically
compensating for supply pressure changes between 1 bar & 10 bars.
To facilitate installation into the wide range of plumbing equipment which is
encountered in the U.K, Four Fixing Options are available:-
Options For Showers
1. MXF "DW" Range - For tting behind Fixed Shower Heads or onto Flexible Hoses
for Handshowers (preferably onto the inlet end when lightweight hoses are used).
2. Compression Fitting Range. "In Line" regulators as in Option 4 for Taps & Mixers.
Haywood House, 40 New Road, Stourbridge, West Midlands DY8 1PA
2 tap
5, 6 or
half open Over
8 l/m
20 l/m
Unregulated Fitted with regulator
TAPS & MIXERS
Regulated
Unregulated
10 - 12 l/m
25 - 30 l/m
SHOWERS
Information by courtesy of
AQUAFLOW REGULATORS LTD
TELEPHONE 01384 442611 FAX: 01384 442612
Page 45
APPENDIX
1
2
1
1
2 2
4 Fixing Options For Taps & Mixers
1. MK Range - Combined Regulators & Aerator
for screwing onto Taps & Mixers with internal
or external threads on their noses. Anti Vandal
models also available.
2. MR05-T Range - Internal Regulators. Push-
fit into Tap or Mixer seats. Produced in
three sizes - 12.5mm (BS1010), 12mm &
10mm, Flangeless models also available for
Taps with Low Lift washers.
3. MXF Standard Range - Screw on tail
models for Taps & Mixers. Fix onto the tails
before tting the tap connectors. Available
in 3/8", 1/2", 3/4" and 1" BSP.
4. Compression Fitting Range - "In Line"
regulators housed in 15mm & 22mm CXC
Couplers & Isolating Valves. " "UK WFBS listed
by the Water Research Centre. Isolation valves
available for slotted screwdriver operation or
with coloured plastic handles. Now available
also in plastic bodied push- t couplers &
valves.
3
3
1
4
APPENDIX A