Page 1
Safety and Reference Please read this manual carefully before operating your set and retain it for future reference. *MFL71783503* www.lg.com Copyright 2021 LG Electronics Inc. All Rights Reserved. (2103-REV01)
Page 2
Title Warning! Safety instructions Connections Preparing Troubleshooting - Lifting and moving the TV Specifications - Installation - Antenna/Cable - Open Source Software Notice Information - Satellite dish - Licenses Starting TV Precautions for Protecting the OLED TV - Turning on the TV Screen - Registering Magic Remote Control...
Page 3
Warning! Safety instructions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Page 4
• Disconnecting the Device from the Main Power • If any of the following occur, unplug the product - The power plug is the disconnecting device. In case of an immediately and contact your local customer service. - The product has been damaged. emergency, the power plug must remain readily accessible.
Page 5
• Batteries - Store the accessories (battery, etc.) in a safe location out of the reach of children. - Do not short circuit, disassemble, or allow the batteries to overheat. Do not dispose of batteries in a fire. Batteries should not be exposed to excessive heat. - Caution: Risk of fire or explosion if the battery is replaced by an incorrect type.
Preparing Lifting and moving the TV Please note the following advice to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. • It is recommended to move the TV in the box or packing material that the TV originally came in. •...
Installation • It is recommended to install the product on the floor. 10 cm ≦ 2 cm ≦ • Do not apply foreign substances (oils, lubricants, etc.) to the screw parts when assembling the product. (Doing so may damage the product.) •...
Starting TV Turning on the TV You can simply operate the TV functions, using the button. Using button Power On (Press) Power Off (Press and hold) 1) All running apps will close, and any recording in progress will stop. (Depending on Volume Control country) Programmes Control...
Inserting the battery When the message [Magic Remote battery is low. Please change the battery.] is displayed, replace the battery. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching the ends to the label inside the compartment, and close the battery cover. (If you lose the supplied pin, you can use a pointed object instead.) •...
Page 10
Connecting Smart Devices using NFC Tagging Using the NFC Feature NFC is technology that uses Near Field Communication, allowing you to conveniently send and receive information without separate settings. By bringing a smart device near the NFC-enabled remote control, you can install the LG ThinQ app and connect the device to the TV. 1 Turn on NFC in the smart device’s settings.
Using Remote Control Using Magic Remote Control (Depending on model) The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. Power Turns the TV on or off. Microphone STB Power You can turn your set-top box on or off by adding the set-top box to the...
Page 12
Connections Connect various external devices to the TV and switch input modes to select an external device. For more information of external device’s connection, refer to the manual provided with each device. • The product label is attached under the external device connection terminal cover. •...
Page 13
CI module View the encrypted (pay) services in digital TV mode. (Depending on model) • Check if the CI module is inserted into the in the right direction. If the module is not Note inserted properly, this can cause damage to the TV and the •...
Troubleshooting • Check the remote control sensor on the product and try again. Cannot control the TV with the remote • Check if there is any obstacle between the product and the remote control. control. • Check if the batteries are still working and properly installed ( to , to ).
Specifications (Depending on country) Broadcasting Specifications Digital TV Analogue TV PAL B/B, PAL B/G, DVB-T/T2 PAL D/K, PAL-I, Television system DVB-C SECAM B/G, SECAM D/K, DVB-S/S2 NTSC-M DVB-S/S2 DVB-C DVB-T/T2 VHF III : 174 ~ 230 MHz UHF IV : 470 ~ 606 MHz Program coverage 46 ~ 862 MHz 950~2,150 MHz...
Page 16
Environment condition Operating Temperature 0 °C to 40 °C Operating Humidity Less than 80 % Storage Temperature -20 °C to 60 °C Storage Humidity Less than 85 % • For information of the power supply and power consumption, refer to the label attached to the product. - The typical power consumption is measured in accordance with IEC 62087 or each country’s energy regulations.
Open Source Software Notice Information To obtain the source code under GPL, LGPL, MPL, and other open source licenses, that is contained in this product, please visit http://opensource.lge. com . In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download. LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping, and handling) upon email request to opensource@lge.com .
Page 18
Precautions for Protecting the OLED TV Screen Unlike regular LED/LCDs, OLED TVs produce images that emit light for each pixel, achieving a perfect black colour and delivering clear images without blurring. Due to the nature of the organic materials used to achieve high-resolution image quality, OLED displays generally experience image retention on the screen, which can be a persistent phenomenon.
Page 19
Recommendations for Minimising Image Retention → [Picture] → [Select Mode] and set the mode When watching the TV for a long time, press the button on the remote control, go to to [Eco], go to [Advanced Settings] → [Brightness] and set [OLED Pixel Brightness] to a lower level. In addition, press the button on the →...
Page 22
The model and serial number of the product are located on the back and on one side of the product. Record them below in case you ever need service. Model Serial No.
Need help?
Do you have a question about the 88Z19LA and is the answer not in the manual?
Questions and answers