: Depending on model / Abhängig vom Modell / Selon le modèle / In base al modello / En función del modelo / Dependendo do modelo / Afhankelijk van het model /
Ανάλογα με το μοντέλο / Odvisno od modela / Típusfüggő / Zależnie od modelu / Závisí na modelu / V závislosti od modelu / În funcţie de model / В зависимост
от модела / Sõltub mudelist / Priklauso nuo modelio / Atkarībā no modeļa / U zavisnosti od modela / Ovisno o modelu / Në varësi të modelit / Ovisno o modelu /
Во зависност од моделот / Beroende på modell / Avhengig av modell / Afhængigt af modellen / Mallin mukaan /
Summary of Contents for LG SIGNATURE OLED77G7 Series
Page 1
OLED TV OLED65G7* OLED77G7* CR2032 OLED65G7* (M4 X L10) (M10 X L70) OLED77G7* X 18 (M8 X L77) (M8 X L25) (M4 X L12) : Depending on model / Abhängig vom Modell / Selon le modèle / In base al modello / En función del modelo / Dependendo do modelo / Afhankelijk van het model / Ανάλογα...
Page 7
ANTENNA / CABLE IN HDMI IN HDMI IN/ARC USB IN AUDIO OUT/ H/P OUT...
Page 8
AUDIO OUT/ H/P OUT Satellite IN OPTICAL DIGITAL AUDIO OUT...
Page 9
AV IN COMPONENT IN VIDEO L/MONO AUDIO R AUDIO VIDEO...
Page 12
1461 31.7 OLED65G7V-Z 1734 1055 1067 54.1 OLED77G7V-Z AC 100-240 V ~ 50 / 60 Hz Power requirement...
Page 13
Safety and Reference Please read this manual carefully before operating your set and retain it for future reference. www.lg.com *MFL69727242* P/NO : MFL69727242 (1704-REV01) Printed in Korea...
Page 14
Warning! Safety instructions • Do not touch the power plug with wet hands. Additionally, if the cord pin is wet or covered with dust, dry the power plug completely or wipe dust off. You may be electrocuted due to excess moisture. •...
Page 15
• Do not put or store inflammable substances near the product. There is • Only use an authorized AC adapter and power cord approved by a danger of combustion/explosion or fire due to careless handling of LG Electronics. Otherwise, this may result in fire, electric shock, the inflammable substances.
Page 16
• Signal from Remote Control can be interrupted due to external/ • As long as this unit is connected to the AC wall outlet, it is not internal lighting eg Sunlight, fluorescent lighting. If this occurs turn disconnected from the AC power source even if you turn off this unit off lighting or darken viewing area.
Page 17
Preparing • When supported cable is not long enough to connect TV set with Companion Box (AV Box), you can use an extension cable. (Only OLED65/77W7V) • If the TV is turned on for the first time after it was shipped from the •...
Lifting and moving the TV • Avoid touching the screen at all times, as this may result in damage to the screen. • Do not move the TV by holding the cable holders, as Please note the following advice to prevent the TV from being scratched the cable holders may break, and injuries and damage or damaged and for safe transportation regardless of its type and size.
Securing the TV to a wall Basic functions (This feature is not available for all models.) Power On (Press) Power Off (Press and hold) Volume Control Programmes Control 1 All running apps will close, and any recording in progress will stop. 1 Insert and tighten the eye-bolts, or TV brackets and bolts on the Adjusting the menu back of the TV.
Mounting on a wall • Fold the AV box before installing the TV on a wall mount by performing the stand type installation in reverse. (This feature is not available for all models.) • To install the wall mount, switch the selector to as shown in the figure below.
• Check the material of the wall and the thickness of the finishing. Provided item • Use the Wall mount anchor for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack. Wall Material Tools Wall Width...
How to attach to masonry walls • Make sure that children do not climb on or hang on Please follow the below direction. the TV. • Use a platform or cabinet that is strong and large 1 Use a drill bit Ø 8 mm to drill a hole for the anchor location within a enough to support the TV securely.
Using the kensington security Antenna connection system Connect the TV to a wall antenna socket with an RF cable (75 Ω). • Use a signal splitter to use more than 2 TVs. (Only OLED65W7*) • If the image quality is poor, install a signal amplifier properly to The Kensington security system connector is located at the rear of improve the image quality.
Other connections (POWER) Turns the TV on or off. Connect your TV to external devices. For the best picture and audio quality, connect the external device and the TV with the HDMI cable. You can turn your set-top box on or off by adding the set-top Some separate cable is not provided.
Magic remote functions Adjusts the volume level. Scrolls through the saved programmes. (MUTE) Mutes all sounds. When the message “Magic remote battery is low. Change the battery.” is - Pressing and holding the button accesses the Accessibility menu. displayed, replace the battery. (Voice recognition) To replace batteries, open the battery cover, replace batteries (1.5 V AA) matching the...
Licenses Streaming Service buttons Connects to the Video Streaming Service. (INPUT) Changes the input source. Supported licenses may differ by model. For more information about - Pressing and holding the button displays all the lists of external licenses, visit www.lg.com. inputs.
Troubleshooting Abnormal Display • If the product feels cold to the touch, there may be a small “flicker” when it is turned on. This is normal, there is nothing wrong with Cannot control the TV with the remote control. product. •...
Generated Sound 100.0 mm x 55.0 mm x CI Module (W x H x D) • “Cracking” noise: A cracking noise that occurs when watching or 5.0 mm turning off the TV is generated by plastic thermal contraction due to Operating temperature and humidity.
Page 29
(Depending on country) Digital TV Analogue TV DVB-T DVB-T2 PAL/SECAM, B/G, D/K, I Television system DVB-C SECAM L DVB-S/S2 DVB-S/S2 DVB-C DVB-T/T2 VHF III : 174 ~ 230 MHz Channel coverage UHF IV : 470 ~ 606 MHz 46 ~ 862 MHz (Band) 950 ~ 2150 MHz 46 ~ 890 MHz...
OWNER’S MANUAL EXTERNAL CONTROL DEVICE SETUP Please read this manual carefully before operating the set and retain it for future reference. www.lg.com...
KEY CODES KEY CODES • This feature is not available for all models. Code Code Function Note Function Note (Hexa) (Hexa) CH +, PR + R/C Button List R/C Button CH -, PR - R/C Button Exit R/C Button Volume + R/C Button PIP(AD) R/C Button...
Page 33
EXTERNAL CONTROL DEVICE SETUP EXTERNAL CONTROL DEVICE SETUP • Image shown may differ from your TV. Connect the USB to Serial converter/RS-232C input jack to an external control device (such as a computer or an A/V control system) to control the product’s functions externally. Note: The type of control port on the TV can be different between model series.
Page 34
EXTERNAL CONTROL DEVICE SETUP (TV) (PC) (TV) (PC) Phone jack Type RS-232C IN • You need to purchase the phone-jack to RS-232 cable required for the connection between the PC and (CONTROL & SERVICE) (PC) (TV) the TV, which is specified in the manual. RS-232C IN (CONTROL &...
EXTERNAL CONTROL DEVICE SETUP Communication Parameters • Baud rate : 9600 bps (UART) • Stop bit : 1 bit • Data length : 8 bits • Communication code : ASCII code • Parity : None • Use a crossed (reverse) cable. Command reference list (Depending on model) DATA...
EXTERNAL CONTROL DEVICE SETUP Transmission / Receiving Protocol Transmission [Command1][Command2][ ][Set ID][ ][Data][Cr] [Command 1] : First command to control the TV. (j, k, m or x) [Command 2] : Second command to control the TV. [Set ID] : You can adjust the [Set ID] to choose desired monitor ID number in option menu. Adjustment range in TV is 1 to 99.
Page 37
EXTERNAL CONTROL DEVICE SETUP * Commands may work differently depending on model and signal. 01. Power (Command: k a) Ack [d][ ][Set ID][ ][OK/NG][Data][x] ► To control Power *On or Off of the set. * In case of video mute on only, TV will display On Transmission[k][a][ ][Set ID][ ][Data][Cr] Screen Display(OSD).
Page 38
EXTERNAL CONTROL DEVICE SETUP Data Min : 00 to Max : 64 * (Depending on model) Ack [i][ ][Set ID][ ][OK/NG][Data][x] 14. Bass (Command: k s) 09. Tint (Command: k j) ► To adjust Bass. ► To adjust the screen tint. You can also adjust in the AUDIO menu.
Page 39
EXTERNAL CONTROL DEVICE SETUP Set ID = All = 00 5th Band 20(decimal) Data 00 & 01 = Channel Data is 10 = 00 0a Acknowledgement [v][ ][Set ID][ ][OK/NG][Data][x] Data 02 = Analog Antenna TV = 00 Result = ma 00 00 0a 00 * It depends on model, and can adjust when sound mode is EQ adjustable value.
Page 40
EXTERNAL CONTROL DEVICE SETUP Number Data 05 = Digital Antenna TV = 02 - 22 : Antenna TV (DTV) – Don’t Use Physical Total = ma 00 00 00 11 00 01 02 Channel Number - 26 : Cable TV (CADTV) - Don’t Use Physical 2.
Page 41
11 11 EXTERNAL CONTROL DEVICE SETUP 24. Input select (Command: x b) (Main Picture Input) ► To select input source for main picture. Transmission [x][b][ ][Set ID][ ][Data][Cr] Data X : don’t care 00 : DTV 01 : CADTV 02 : Satellite DTV 10 : ATV Ack [t][ ][Set ID][ ][OK][Data00][Data01][Data02] ISDB-BS (Japan)
Page 42
EXTERNAL CONTROL DEVICE SETUP 27. Auto Configure (Command: j u) (Depending on model) ► To adjust picture position and minimize image shaking automatically. It works only in RGB (PC) mode. Transmission [j][u][ ][Set ID][ ][Data][Cr] Data 01 : Run Auto Configure Ack [u][ ][Set ID][ ][OK/NG][Data][x]...
Need help?
Do you have a question about the OLED77G7 Series and is the answer not in the manual?
Questions and answers