3000 Controller Useful Codes; Service Required Errors - Frymaster FootPrint PRO OCF30 Series Service & Parts Manual

1.12.2 3000 Controller Useful Codes

To enter any of the following codes: Press and hold the  button until Main Menu changing to
Product setup is displayed. Press  to scroll to Tech Mode and press .
MODE ENTER CODE is displayed. Enter a code number below:
 Change Fryer Type, CE/Non-CE, Fresh Oil Setup, Waste Oil Setup and Energy
Type – Enter 7628.
 Clear E-Log, Clear Passwords, Change Lane Count, Adjust Max Cook Temp and
Perform High Limit Test, – Enter 3000.
 Reset Factory Menu - Enter 3322. The controller display flashes and quickly counts
from 1-40 and switches to off. (NOTE: This will delete any hand-entered menu items).
 Reset BADCRC Message - Disconnect board locator plug (J3). Reinsert plug. Enter
Controller display switches to off. Remove and then restore power to the
9988.
controller using the 20-pin plug.
 Change from F° to C° - Enter 1658. The controller displays off. Turn the controller
on and check temperature to see the temperature scale. If the desired scale is not displayed,
repeat.
 Reset RECOVERY FAULT CALL SERVICE – Enter 0042.
PASSWORDS
Product Setup Mode: Press and hold the  button until Main Menu changing to Product
setup is displayed. Press the  button. ENTER CODE is displayed. Enter 1650.
Vat Setup Mode: Press and hold the  button. Main Menu changing to Product setup
is displayed. Press  to scroll to Vat Setup and press . ENTER CODE is displayed. Enter
1656.
Tech Mode: Press and hold the  button until Main Menu changing to Product setup
is displayed. Press  to scroll to Tech Mode and press .
the  button. ENTER CODE is displayed. Enter 3000 or a code from above.

1.12.3 Service Required Errors

A SERVICE REQUIRED error alternating with YES displays on the controller. After YES is pressed the
alarm is silenced. The controller displays an error message from the list below three times with the
location of the error. Then the controller displays SYSTEM ERROR FIXED? YES/NO. Press YES if error
is fixed. If NO is chosen the system returns to cook mode for 15 minutes then redisplays error until
issue is fixed.
TECH MODE is displayed. Press
1-22
TECH