ATEN Altusen KH1516A User Manual page 46

KH1508A / KH1516A / KH1532A User Manual
Setting
EDIT PORT To identify which computer is attached to a particular port, every port
NAMES can be assigned a name. This function allows the administrator to
create, modify, or delete port names. To assign a port name:
1. Click the port you want, or use the navigation keys to move the
highlight bar to it, then press [Enter].
2. Key in the new port name, or modify/delete the old one. The maxi-
mum number of characters allowed for the port name is 14. Legal
characters include:


*You can enter the port names in either upper or lower case
however the OSD displays the port name only in UPPERCASE.
3. When you have finished editing, press [Enter] to have the change
take effect. To abort the change, press [Esc].
RESTORE This function is used to undo all changes and return the setup to the
DEFAULT original factory default settings (see OSD Factory Default Settings,
VALUES
page 75)
ports, which are saved.
CLEAR THE This function clears the port name list.
NAME LIST
RESET If you change the position of one of the stations in the daisy chain, the
STATION IDS OSD settings will no longer correspond to the new situation. This
function directs the OSD to rescan the station positions of the entire
installation and updates the OSD so that the OSD station information
corresponds to the new physical layout.
Note: Only the station numbers get updated. Except for the port
names, all administrator settings (such as Set Accessible Ports, Set
Quick View Ports, etc.), for all of the computers affected by the change,
have to be manually redone.
SET Specifies the operating platform of the computer attached to each port.
OPERATING You must configure each port on the installation. For each port, press
SYSTEM the [Spacebar] to cycle through the choices (PC, Mac or Sun). Repeat
until all the ports have been set, then press [Esc]. The default is PC.
Note: If you are installing a Sun or Mac computer it may not boot when
you run it for the first time unless you first set the correct operating
system for the port it is connected to.
SET CAT 5 Lets you specify how long the Cat 5e/6 cable between the port and the
LENGTH KVM adapter cable is. Press [Spacebar] to cycle through the cable
length settings:
S: Short – for up to 25 m
M: Medium – for between 20 and 35 m
L: Long – for above 35 m
An S, M, or L appears next to the port to indicate the choice.
34
All alpha characters: A–Z*
All numeric characters: 0–9
–
except for the Names settings that were assigned to the
Function