Humidifying Filter Drying Operation; Airflow Rate Limit When The Water Supply Lamp Is Lit; Notification Tone When Water Supply Lamp Is Lit - Daikin MCK70ZBFVMW Operation Manual

Advanced Settings
Advanced Settings
Function
Humidifying Filter Drying
Operation
(ON/OFF)
Setting at the time of purchase: ON
Humidifying filter drying operation is
automatically started when operation is
stopped after Humidifying Operation is
performed in AUTO Operation, MODE
operation, or Humidifying and Air Purifying
Operation.
(This shortens the period when the
humidifying filters are left semi-damp and
bacteria is likely to propagate.)
• When set to "OFF", Humidifying Filter Drying
Operation will not be performed.
Airflow rate limit when the
water supply lamp is lit
(Quiet/OFF/Fan stop)
Setting at the time of purchase: Quiet
If you do not want the airflow rate set to
"Quiet" when the water supply lamp is lit, set it
to "OFF".
When set to "OFF", even if the water supply
lamp lights up, the airflow rate from before the
lamp lit up continues.
If you are concerned about the odour when the
water supply lamp is lit, set to "Fan stop".
Notification tone when water
supply lamp is lit
(ON/OFF)
Setting at the time of purchase: ON
If the notification tone emitted when the water
supply lamp is lit bothers you, set it to "OFF".
• This is a useful function during sleep hours.
• The error notification alarm cannot be turned off.
33
Setting can be performed either
during operation or while operation
is stopped.
Press for about
5 seconds, and when a
short beep sounds, press
while continuing
to hold down
When a short beep
sounds, release
and .
Setting can be performed either
during operation or while operation
is stopped.
Press for about
5 seconds, and when a
short beep sounds, press
while continuing
to hold down .
When a short beep
sounds, release
.
Press for about
3 seconds while
operation is stopped.
1
The humidifier lamp blinks, then
lights up.
[Blinking → Lit up]
According to the current setting,
the FAN lamp will be displayed as
follows.
.
[Blinking → Lit up]
"ON"
The water supply lamp blinks, then
lights up.
[Blinking → Lit up]
According to the current setting,
the FAN lamp will be displayed as
follows.
[Blinking [Blinking
and
↓ ↓
Lit up] Lit up]
"Quiet" "OFF"
Each time
about 3 seconds, the setting
changes.
[Lit up]
"ON"
[Unlit]
"OFF"
[Unlit]
"Fan stop"
is pressed for
[Blinking]
"OFF"