Factory Reset; Installation; Removing The Dome Cover - Idis DirectIP DC-D Series Installation Manual

LED Status Indications
LED Status
Off
Status LED Flashing
On

Factory Reset

Only use the factory reset button to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Shut off the power supply.
2
Remove the dome cover.
3
Press and hold the reset button down
4
Hold the button down and apply the power.
5
Once the device turns back on, wait 5 seconds and
then release the reset button.
6
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
It's also possible to do a factory reset by pressing and
releasing the reset button while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For more
information on factory reset, refer to the IDIS Discovery
operation manual.
Description
Power not connected
Upgrading
Powered on

Installation

Installation of this product does not require the use of
special tools.
For more information on other devices comprising the
overall system, refer to their respective installation
manuals.
Product color and design may vary depending on the
model.

Removing the Dome Cover

1
Turn the dome cover counterclockwise.
2
Remove the dome cover.
Part 1 – Introduction
9