Part 1 – Introduction
Overview
Product color and design may vary depending on the
model.
Dome Cover
Body
1
2
3
4
5
Lens
1
Network Port
2
Wall/Ceiling Installation Hole
3
Cable Access Hole
4
Bottom Cover
5
8
IR LED
6
Factory Reset Button
7
Status LED
8
• Lens
Features a fixed focus lens.
• Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the IDIS Discovery operation manual.
The following table describes the network cable
specifications.
<The network cable specifications>
Item
Connector RJ-45
Ethernet
Cable
Maximum
length
PoE
• Wall/Ceiling Installation Hole
6
Used to screw the camera in place on a wall or a
ceiling.
7
• Cable Access Hole
8
For routing cables.
• Bottom Cover
Allows you to install the camera on a wall or a ceiling.
• IR LED
A sensor inside the system monitors lighting
levels and activates the IR LED during low-lighting
conditions.
• Factory Reset Button
Restores the camera's default factory settings. For
more information, refer to the Factory Reset.
• Status LED
Indicates the system's operating status. For more
information, refer to the LED Status Indications.
Content
Note
10/100 Base
10/100 Mbps
UTP Category 5e or
higher
100m
IEEE 802.3af, Class 2