58 Operating in SnapVUE™
3.1 First-time Use
SnapVUE™ mode is not accessible yet the first time you install the battery
to the Mobile Computer. You need to power on the Mobile Computer
first before SnapVUE starts to operate as an instant-on mode. After that,
SnapVUE is always accessible even when the power is turned off.
To access SnapVUE mode
•
Press the SnapVUE button.
Note
Calibrate the touch screen
The first time you use SnapVUE
mode, you will be prompted to
calibrate the touch screen. As the
cross moves around the screen,
tap the center of the cross with
the stylus. This process allows
the touch screen to accurately
respond to stylus or finger taps
when you're using SnapVUE
mode.
Tip
SnapVUE
button
To always keep SnapVUE in instant-on mode, do not remove the battery from
your Mobile Computer. If you remove and reinsert the battery, you need
to start up the Mobile Computer in Vista® mode first before you can access
SnapVUE mode.
To recalibrate the touch screen in SnapVUE mode at any time, tap Settings >
Screen > Alignment tab then tap Align Screen.