Tripp Lite SmartOnline AGPS8294 Series Owner's Manual page 7

Basic Connection and Start-Up
Quick Start Guide - First Time UPS Power-On
1 Plug your UPS line cord into an electrical outlet
Your UPS must be connected to a dedicated circuit of sufficient
amperage.
Refer to the rating table labelled on the UPS for more details.
2
Select your Language
When your UPS is plugged in for the first time, the INPUT AC
LED will light up and the front panel LCD screen will request a
language selection.
Using the UP / DOWN buttons
preference, then press the NEXT
The interface will confirm your selection and provide options to
go back (press BACK ) or to go to the next step
ESC
(press NEXT ).
Language
English
Back
SETUP
ESC
2
4 Select your Password
Next, the UPS will prompt you to pick the desired PASSWORD.
Using the UP / DOWN
your desired password and press the NEXT
advance to the second digit. Repeat for digits 2 through 4.
Note: To quickly set the password to "0 0 0 0" press the NEXT button 4 times.
Password Setup
0 0
Back Select Next
SETUP
ESC
4
, select your language
button.
Next
buttons, select the first digit of
button to
0 0
1
3 Select your Power Strategy
Next, the UPS will prompt you to pick the desired POWER
STRATEGY.
Using the UP / DOWN
STRATEGY preference and press the APPLY
See the Power Strategy Selection Options and UPS
Operating Modes sections under the Operations section for
operating characteristics of each power strategy.
Power Strategy
Auto-Adaptive
Max Efficiency
Max Quality
Freq. Regulation
Freq. Conv. To 60Hz
Freq. Conv. To 50Hz
Back Select Apply
ESC
3
5 Select UPS Output Voltage
Next, the UPS will prompt you to select the desired OUTPUT
VOLTAGE.
Using the UP / DOWN
voltage, then select APPLY
Output Voltage
200 Vac
208 Vac
220 Vac
230 Vac
240 Vac
Back Select Apply
ESC
5
7
buttons, select your POWER
button.
SETUP
buttons, select the UPS output
.
SETUP