Tripp Lite SmartOnline AGPS8294 Series Owner's Manual page 6

Installation
Smart Battery Communications Connection
Your UPS supports automatic detection of its internal batteries and up to 6 external SMART BATTERY PACKS. Prior to powering up the
UPS from AC mains power, you must connect the internal SMART BATTERY communication cable in the following manner:
1
Remove the 4 front screws from the front bezel and take it off.
1
3
Open the front plate.
3
5
Tighten the 2 screws to secure the front plate.
5
EXTERNAL BATTERY CONFIGURATION NOTE
If external battery packs are to be used with this UPS, install them following the mounting/installation documentation included with each
battery pack. External battery pack installation requires the UPS be configured one of two ways:
1. Via the UPS front panel LCD interface
2. Via Tripp Lite's EXTERNAL BATTERY CONFIGURATION software
This UPS is factory programmed with discharge curves and charging profiles for external battery pack configurations accessible using the
UPS front panel LCD interface. Additional battery pack options using larger or multiple external battery packs are also supported, but
require configuration using Tripp Lite's EXTERNAL BATTERY CONFIGURATION software and a serial port connection to the UPS.
2
Loosen the 2 screws securing the front plate.
2
4
Connect the SMART BATTERY communication cable. Close the
front plate.
2
4
6
Replace the 4 front screws to secure the bezel.
6
6
1