General Operating Instructions; Switching On/Off The Device - Medion GoPal E570 Series Instruction Manual

PLEASE NOTE!
You will not be able to select the Navigation menu or the settings if the
navigation software does not find any map files in the device or on a
memory device. Then the Extras menu will appear automatically.
Brief pressure on the on/off button will be enough to switch the device
on or off, provided that your navigation system is connected to an
external source of electricity or is running in battery operation (standby
mode).
You can adjust the period of operation to suit your needs using the
Settings button on the main screen of your device. Your device is
delivered in a status in which it will not switch off independently.
Press and hold the On/Off key, to completely switch off the device.
No data will be lost as data is stored in the internal memory. The starting
process will only last slightly longer.
Your navigation system will use a low amount of electricity and the batteries will be
discharged, even when in standby mode.
The final installation of the navigation software will take place automatically from
the internal memory, during the initial set up, if your device has already been
equipped with the basic data of the navigation software at the factory. Follow the
instructions on the screen.
An optional memory card must always be inserted in the device while the
navigation system is being used.
It will be necessary to carry out a Reset to restart the navigation system if the
memory card has been removed (see page 27).
Please also read the chapter Navigation starting on page 28.

6. General Operating Instructions

6.1. Switching on/off the Device
Your device will be in its normal operating state after the initial set up. You can
activate and deactivate your device with the On-/Off switch.
 To start your navigation system press briefly the On-/Off switch.
PLEASE NOTE!
Your device is delivered in a status in which it will not switch off
independently. You can adjust the period of operation to suit your needs
using the Settings button on the main screen of your device.
Your navigation system will use a low amount of electricity and the
batteries will be discharged, even when it is in the standby mode.
20 of 82