Placing Your Stove - Pelpro PP130 Owner's Manual

Installing Your Stove

Placing Your Stove

It is necessary to install EMBER PROTECTION; a Type 1 floor protector for this Stove.
1
The Floor protector must be non-combustible material, extending beneath Stove with a minimum
of 6 inches (152mm) in front of glass and 6 inches (152mm) to both sides of the fuel loading
door. Open the door and measure 6 inches (152mm) from the side edge of the opening in the
face of the Stove.
Notice: Be careful to protect the bottom of the Stove and floor surfaces when moving the Stove. Bottom
edges of Stove are sharp and can scratch surfaces.
Notice: Clearances may only be reduced by means approved by the regulatory authority having jurisdiction.
Hearth pad minimum requirements:
2
USA Hearth Pad Requirements
A
B
C
Canada Hearth Pad Requirements
A
B
C
Non-combustible floor protection extending beneath the flue pipe is required with horizontal venting or under the top vent
adapter with vertical installation.
*Non-combustible floor protection must extend 2 inches (51mm) beneath the flue pipe when installed horizontal venting or
under the top vent adapter with vertical installation. CANADA REQUIRED, USA RECOMMENDED.
pelprostoves.com
1
Inches
Sides 2
Back 2
Front 6
Inches
Sides 6
Back 2
Front 6
PelPro Pellet Stove • 7104-171C • 10/3/18
2
mm
51
51
152
mm
152
51
152
B*
A A
C
9