Using Your Stove
What Do the Blinking Lights Mean?
Green & Amber - Normal Operation
•
Green, Steady On - Feed system is priming
•
Green, 1 Blink - Stove is off and ready
•
Green, Continuous Blinking - Stove is in the start up/ignition sequence
•
Green, Varies Blinks - Varies depending on burn rate
•
Amber, Steady On - Stove is set and running at either the minimum or maximum power
levels
•
Amber, Continuous Blinking - Stove is in the shutdown sequence. *Early models may have
a green continuous blinking light during shutdown sequence.
Red - Operational Issue - Refer to troubleshooting
•
Red, 1 Blink - Empty hopper, refer to troubleshooting
•
Red, 2 Blinks - Exhaust probe alarm, check connections or refer to troubleshooting
•
Red, 3 Blinks - Ambient probe alarm, check connections or refer to troubleshooting
•
Red, 4 Blinks - Missed ignition, refer to troubleshooting
•
Red, 8 Blinks - Exhaust gas over temperature, refer to troubleshooting
If your Stove does not ignite on the initial burn, the LED light will blink
red 4 times indicating a missed ignition.
1. Turn your Stove to off, remove and clean the fire pot
2. Confirm fire pot is properly positioned
3. Prime your Stove per previous instructions
Is this your first start-up after purchase?
If you just bought this Stove, once a fire has been established in your Stove, leave the Stove burning on
HI for 30 minutes to allow paint to cure.
After 30 minutes, turn the dial control to OFF and allow your Stove to cool completely. Once cooled,
clean the fire pot. Your Stove is now ready to resume normal use.
18
PelPro Pellet Stove • 7104-171C • 10/3/18
5
5
4
4
6
6
3
3
2
2
1
1
LO
LO
10
OFF
HI
OFF
HI
pelprostoves.com
7
7
8
8
9
9
10