Clp-970/970M/970C: Keyboard Stand Assembly - Yamaha Clavinova CLP-970 Owner's Manual

CLP-970/970M/970C:
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
The parts shown in the "Assembly Parts" illustra-
tion will be used. Follow the assembly instructions
and select the parts as needed.
Assembly Parts
1
6 x 25 mm
round-head screws x4
6 x 16 mm
2
flat-head screws x4
3
4 x 12 mm
round-head screws x2
side
panel
(left)
Bundled pedal cord inside
106
CLP-970
4
4 x 20 mm
tapping screws x4
Cord holders x 2
main unit
side
rear panel
panel
(right)
pedal box
AC power cord
1.
Attach the side panels to the pedal box.
Place the plastic bag that contained the side
panels on the floor when assembling the stand
to prevent scratches to the floor or stand.
side panel
(right)
(2) Use the four long
round-head
screws 1 to
attach the pedal
box. First attach
one side panel,
then attach the
other side panel.
2.
Attach the rear panel.
(1) With the rear
panel on the
feet's
protruding
edge, align the
panel with the
(3) Secure the
groove and
bottom of the
secure the top
rear panel to the
of the panel.
pedal box using
four tapping
screws 4.
Make sure the
indented surface on
the side panel and the
rear surface on the
pedal box will match
correctly, without
creating a step.
side panel
(left)
(1) Untie and straighten out the
bundled cord attached to the
bottom of the pedal box.
Don't discard the vinyl tie,
you'll need it later in step 6.
(2) Secure the top of the
rear panel to the side
panel brackets using
two thin round-head
screws 3.