To install the motherboard:
1. Review the documentation that came with your motherboard. Become familiar
with component placement, requirements, precautions, and cable connections.
2. Open the chassis cover.
3. Remove the riser card bracket.
4. As required by your motherboard, install standoffs in any areas that do not
have a permanent standoff. To do this:
A. Place a hexagonal standoff screw through the bottom the chassis.
B. Secure the screw with the hexagon nut (rounded side up).
5. Lay the motherboard on the chassis aligning the permanent and optional
standoffs
6. Secure the motherboard to the chassis using the rounded, Phillips head
screws.
7. Secure the CPU(s), heatsinks, and other components to the motherboard as
described in the motherboard documentation.
8. Connect the cables between the motherboard, backplane, chassis, front panel,
and power supply, as needed. Also, the blowers may be temporarily removed
to allow access to the backplane ports.
9. Replace the riser card bracket. If you are installing an add-on card, skip for-
ward in this manual for add-on card installation instructions.
Chapter 4: Chassis Setup and Maintenance
4-5