Dataman 448PRO2AP-AU User Manual page 55

Setup
DATAMAN 48PRO2AP can be mounted with left side on base plate by 4 screws M3. Length
of screw depends on base plate thickness.
Attention: Before mounting DATAMAN 48PRO2AP in this way, unscrew two screws M3
located on left side. Then replace them with new M3 screws with proper length. For proper
mounting of programmer on base plate, mounting screws must be minimal 3mm depth in
programmer. To avoid damage of PCB in programmer mounting screws must be maximum
8mm depth in programmer.
Drawing for mounting programmer with left side on base plate:
.
55