Dataman 448PRO2AP-AU User Manual page 43

Setup
Installation to target system
This chapter contains mechanical drawing of DATAMAN 448PRO2AP-AU, DATAMAN
448PRO2AP and DATAMAN 48PRO2AP and other information needed for installation
DATAMAN 448PRO2AP-AU, DATAMAN 448PRO2AP and DATAMAN 48PRO2AP to target
system.
DATAMAN 448PRO2AP-AU
On picture bellow are overall dimensions of DATAMAN 448PRO2AP with pressure plate at
upper position.
Right top view to DATAMAN 448PRO2AP-AU with dimensions
At X axis a center of ZIF is same with center of programming module, but at Y axis not. For a
lot of ZIFs, they center will be at the same position as on picture, but for some extra big ZIFs
center of ZIF will be moved at Y axis.
Notes:
Minimal distance between programmers must be:
 2+ cm in face to face configuration of programmers
 5+ cm in tail to face configuration of programmers
43