Dataman 448PRO2AP-AU User Manual page 106

The real fee for credit is very low, it starts at about 0.01 USD per credit for CB-25k version of
Credit box (= 25 thousands credits) and goes steeply down up to about 0.003 USD per credit
for CB-500k version of Credit box (= 500 thousands credits).
The validity of Credit box is limited to 10 regular versions of software. It means, once the
Credit box is activated at the time of first usage, it can be used by current and by next 9 regular
versions of software.
Example: activated by 3.01 version of software can be used by 3.01, 3.02... up to 3.10 version
of software (including all OnDemand versions).
Credit box status is displayed in main window of PG4UW and PG4UWMC software.
See please the Application note Usage of Credit box for devices in 'Paid ISP support' category
at our web site for details.
Programmer / Module options
This option is used for multiple socket programmers for defining MASTER socket and activity
of each socket. MASTER socket group box allows user to set socket which is preferentially
used for device reading operation. Enable/Disable socket checkbox array allows user to set
enabling and disabling of each socket individually. Disabled sockets are ignored for any device
operation.
Programmer / Automatic YES!
This command is used for setting Automatic YES! mode. In this mode you just take off the
programmed device, then put new device into ZIF socket and a last operation will be repeated
automatically. Program automatically detects an insertion of a new device and runs last
executed operation without pressing any key or button. An insertion of device into ZIF is
displayed on the screen. Repeated operation executing will be cancelled by pressing key
<ESC> during waiting for insert/remove a device to/from ZIF socket.
After an operation with a device is executed, one of the OK or ERROR (status) LEDs on the
programmer will lights in dependence on the result of an operation and the BUSY LED will
blinking.
If the program detects removal of a device, then status LED will switched off, but the BUSY
LED will still blinking to indicate readiness of the program to repeat last operation with new
device.
After the program indicates one or more pins of (new) device in the ZIF socket of the
programmer, the BUSY LED will goes to light continually. From this the program will wait a
requested time for insert the rest pins of new device. If a requested time (Device insertion
complete time) overflows and a device is not correctly inserted, the program will light the
ERROR LED to indicate this state. After new device was inserted correctly, the program will
switch off all status LEDs, except BUSY, and will start an operation with new device.
This mode may be enabled or disabled by item Automatic YES! mode. If a new programmer
is selected Options / Find programmer, this mode will be disabled.
The Response time is interval between insertion of the chip into the ZIF socket and the start
of selected device operation. If longer positioning of the chip in the ZIF socket is necessary
select elongated response time.
106