Related Documentation; Safety; General Safety; Rf Safety - Multitech MTCBA-E1-U User Manual

Chapter 1 – Product Description and Specifications

Related Documentation

The following table describes additional documentation for each model.
Model
MultiModem MTCBA-E1 (EDGE)
MultiModem MTCBA-G2 (GPRS)
MultiModem MTCBA-C1 (CDMA)
MultiModem MTCBA-H5 (HSPA+)

Safety

General Safety

The modem is designed for and intended to be used in fixed and mobile applications. Fixed means the device is
physically secured at one location and cannot be easily moved to another location. Mobile means the device is
used in other than fixed locations.

RF Safety

Due to the possibility of radio frequency (RF) interference, it is important that you follow any special regulations
regarding the use of radio equipment. Follow the safety advice given below.
Caution: Maintain a separation distance of at least 20 cm (8 inches) between the transmitter's antenna and
the body of the user or nearby persons. The modem is not designed for or intended to be used in
portable applications within 20 cm of the user's body.
Check your local standards regarding safe distances, etc.
Operating your device close to other electronic equipment may cause interference if the equipment is
●
inadequately protected. Observe any warning signs and manufacturers' recommendations.
Different industries and businesses restrict the use of cellular devices. Respect restrictions on the use
●
of radio equipment in fuel depots, chemical plants, or where blasting operations are in process.
Follow restrictions for any environment where you operate the device.
Do not place the antenna outdoors.
●
Switch OFF your wireless device when in an aircraft. Using portable electronic devices in an aircraft
●
may endanger aircraft operation, disrupt the cellular network, and is illegal. Failing to observe this
restriction may lead to suspension or denial of cellular services to the offender, legal action, or both.
Switch OFF your wireless device when around gasoline or diesel-fuel pumps and before filling your
●
vehicle with fuel.
6
Additional Documentation
You can configure the MultiModem MTCBA-E1 wireless router using the
EDGE AT Commands. For more information refer to the Reference Guide
for the MultiModem Wireless EDGE Modems, part number S000474x.
You can configure the MultiModem MTCBA-G2 wireless modem using
the GPRS AT Commands. For more information, refer to the Reference
Guide for the MultiModem Wireless GPRS Modems, part number
S000463x
You can configure the MultiModem MTCBA-C1 wireless router using the
CDMA-C1 AT Commands. For more information, refer to the Reference
Guide for the MultiModem Wireless CDMA-C1 Modems, part number
S000478x.
You can configure the MultiModem MTCBA-H5 wireless router using the
HSPA+ AT Commands. These commands are documented in the
Reference Guide part number S000528x.
MultiModem Cell User Guide