Interior Light
Full Shelf (Total 3)
Half Shelf (Total 1)
Levelling Legs
NOTES: 1. Models with BI in the model number suffix can be installed either built-in or free-standing.
2. Models with CSS in the model number suffix have cabinets fully wrapped in stainless steel.
3. The metal insert for wine cellars allows you to lay 3 Bordeaux bottles or 2 Burgundy bottles
safely on the floor.
4. Shelves for wine cellars are wooden. Those for beverage merchandisers are chrome-
plated wire.
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
•
CAUTION: After unpacking and
allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect performance
and the lifetime of the unit.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 7.)
INSTALLATION OF YOUR APPLIANCE
• Your appliance is designed to be free-standing, but can be built-in (fully recessed) if the model number
includes the letters "BI". If free standing, the unit should have at least 4" of clearance at both sides, at
the top and at the back to allow for adequate ventilation. If it is built-in, leave at least 3/16" at both
sides, 1/16" at the top and 2" at the rear. Be sure that airflow under the appliance is not blocked. If
installing your appliance inside a cabinet where the front door may be blocked, call our technical
support department at 718-893-3900 ext. 597 for proper cutout and clearance dimensions.
• WARNING: Do not store or install the appliance outdoors.
• CAUTION
:
This appliance is designed for storing and cooling bottles of wine or other beverages. Do
not store perishable food, medicine or other medical products.
LOCATION OF PARTS
Metal floor insert
for WC2 models
(not shown)
INSTALLATION INSTRUCTIONS
before connecting the appliance to the power source,
5
Digital Control Panel
Door
Handle
Security Lock
you MUST
Need help?
Do you have a question about the SCR321LWC2 and is the answer not in the manual?