Table of Contents
Advertisement
1.5.
Settings of the 4 Dip switches (CAN functions – red)
Dip position down is ON and position up is OFF.
Fahrzeug/Navigation
Jaguar XF, Land Rover
Discovery Sport
Jaguar XE 2016
Jaguar XE 2018
Land Rover Discovery 5,
Ranger Rover Evoque, Range
Rover Sport
The experience values of the CAN bus dip settings are only exemplary. If the Can
communication doesn't succeed, try other dip combinations
After each Dip-switch-change a power-reset of the Can-box has to be performed!
2. Installation
To install the interface, first switch off the ignition and disconnect the vehicle's battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
Before a final installation, we recommend a test-run to ensure the compatibility of the
vehicle and the interface. Due to changes in the production of the vehicle manufacturer
there's always a possibility of incompatibility.
2.1.
Place of installation
The interface is supposed to be installed at a suitable location behind the vehicle`s head-
unit. Depending on the vehicle, the head unit may be located at the following places:
Behind the trim panel in the boot on the left (e.g. F-Pace 10.2 inch - not 8 inch)
Under the rear centre console
Under the driver seat
Under the passenger seat.
Version 03.07.2020
Dip 1
Dip 2
Dip 3
OFF
ON
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
HW CAM(V98)/(V16)
Dip 4
OFF
OFF
OFF
OFF
CI-RL3-LR16-8/10
Advertisement
Table of Contents
