Connection - Quadlock - Can; Incontrol Touch Head Unit (8 Inch Monitor - Rl3-Lr16-8) - Car-Interface CI-RL3-LR16-8 Manual

2.3.2. Connection to Quadlock-CAN –
2.3.2.1. INCONTROL TOUCH head unit (8 inch monitor – RL3-LR16-8)
Connect the female 10pin connector of the 10pin Power / CAN cable to the 10pin connector
of the video interface.
Remove the female Quadlock connector of the vehicle harness from the rear-side of the
head-unit and connect it to the male Quadlock connector of the 10pin Power / CAN cable.
Connect the opposite female Quadlock connector of the 10pin Power / CAN cable to the
previously become free male Quadlock connector at the rear-side of the head unit.
Note: If, after connecting the PNP harness, no interface LED lightens up while the ignition is
turned on, refer to chapter "Analogue power supply for the video interface"
Version 03.07.2020 HW CAM(V98)/(V16) CI-RL3-LR16-8/10