Barracuda C400 Quick Start Manual

Barracuda C400 Quick Start Manual

Ng control center

Advertisement

Quick Links

Barracuda CloudGen Firewall
Barracuda NG Control Center C400
https://campus.barracuda.com/doc/43847052/
General
Front
Default Port Configuration
Label OS Notation
PORT1
port1
PORT2
port2
Hardware Specifications
Opening your Barracuda Networks appliance or removing its warranty label unless instructed to
do so by Barracuda Networks support will void your warranty and hardware support.
Barracuda Networks Appliance Safety Instructions
Component
CPU
Memory
HDD (formatted)
Flash Disk
Form Factor
Peripherals
Dimensions (W/D/H)
Net Weight
Power Supply
Power Supply Input Voltage
Barracuda NG Control Center C400
Speed/Type
10/100/1000 MBit RJ45
10/100/1000 MBit RJ45
AMD Athlon Dual Core
2 x 3.5" 250 GB, 7200 rpm
2 x PS/2, VGA, 24-pin parallel port, 4 x USB 2.0
42.7 x 57.4.0 x 4.3 cm
Management Port
X
Specifications
2 GB
4 GB
1U rack mount
16.9 x 22.6 x 1.7 in
12.0 lbs / 5.4 kg
Internal, internal
100 - 240 V, AC
1 / 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C400 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Barracuda C400

  • Page 1 PORT2 port2 10/100/1000 MBit RJ45 Hardware Specifications Opening your Barracuda Networks appliance or removing its warranty label unless instructed to do so by Barracuda Networks support will void your warranty and hardware support. Barracuda Networks Appliance Safety Instructions Component Specifications...
  • Page 2 The hardware specifications list was valid at the time this manual was published. The listed components are subject to change at any time, as Barracuda Networks may change hardware components due to technological advancements. Therefore, the list may not reflect the current hardware configuration of the Barracuda Networks NG Firewall or NG Control Center appliance it...
  • Page 3 In order to establish a console connection to the appliance using a serial cable (DB9 and RJ45), you need to configure the serial port on the terminal using the following parameters: Parameter Value Baud 19200 Bits Stop bit Parity None Handshake None Barracuda NG Control Center C400 3 / 4...
  • Page 4 Barracuda Networks Inc. All specifications are subject to change without notice. Barracuda Networks Inc. assumes no responsibility for any inaccuracies in this document. Barracuda Networks Inc. reserves the right to change, modify, transfer, or otherwise revise this publication without notice.

Table of Contents