Barracuda CloudGen Firewall Warranty and Safety Instructions Opening your Barracuda Networks appliance or removing its warranty label unless instructed to do so by Barracuda Networks support will void your warranty and hardware support. Barracuda Networks Appliance Safety Instructions Always use the power supply shipped with the appliance.
Page 3
The hardware specifications list was valid at the time this manual was published. The listed components are subject to change at any time, as Barracuda Networks may change hardware components due to technological advancements. Therefore, the list may not reflect the current hardware configuration of the Barracuda Networks NextGen Firewall F-Series or NextGen...
Barracuda CloudGen Firewall Your appliance is equipped with a variety of LEDs. One of them is the Status LED. It is labeled either with a heart symbol or the term Status. It indicates the appliance’s operational state by changing colors between green, orange, and red, and by changing between blinking and steady glowing. The table below shows the different meanings of the different glowing states.
Page 5
Barracuda CloudGen Firewall In order to establish a console connection to the appliance using a serial cable (Revision A: DB9, Revision B: RJ45), you need to configure the serial port on the terminal using the following parameters: Parameter Value Baud...
Once set, this flag cannot be deleted through the menu. When Menu to boot into during the rebooted, the appliance will not start Barracuda OS, but ART next reboot instead. You may connect to the appliance by using the serial console or by SSH.
Page 7
Barracuda Networks Inc. All specifications are subject to change without notice. Barracuda Networks Inc. assumes no responsibility for any inaccuracies in this document. Barracuda Networks Inc. reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the NextGen F Series and is the answer not in the manual?
Questions and answers