Supermicro 2028R-E1CR24L User Manual page 74

S S S
UPER TORAGE YSTEM 2028R-E1CR24L User's Manual
7-5 IPMI
This submenu allows the user to configure Intelligent Platform Management Inter-
face (IPMI) settings.
System Event Log

Enabling/Disabling Options
SEL Components
Select Enabled to enable all system event logging support at bootup. The options
are Enabled and Disabled.
Erasing Settings
Erase SEL
Select Yes, On next reset to erase all system event logs upon next system reboot.
Select Yes, On every reset to erase all system event logs upon each system reboot.
Select No to keep all system event logs after each system reboot. The options are
No, Yes, On next reset, and Yes, On every reset.
When SEL is Full
This feature allows the user to determine what the AMI BIOS should do when the
system event log is full. Select Erase Immediately to erase all events in the log when
the system event log is full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for
the changes to take effect.
7-42
BMC Network Configuration

The following items will be displayed:
•
IPMI LAN Selection
•
IPMI Network Link Status
Update IPMI LAN Configuration
Select Yes for the system BIOS to automatically reset the following IPMI settings
upon next system boot. The options are Yes and No.
Configuration Address Source (Available when the item above - Update
IPMI LAN Configuration is set to Yes)
Use this item to select the IP address source for this computer. If Static is selected,
you will need to know the IP address of this computer and enter it to the system
manually in the field. If DHCP is selected, AMI BIOS will search for a DHCP (Dy-
namic Host Configuration Protocol) server attached to the network and request
the next available IP address for this computer. The options are DHCP and Static.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each
three-digit number is separated by dots and it should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are
6 two-digit hexadecimal numbers.
Gateway IP Address
This item displays the Gateway IP address for this computer. This should be in
decimal and in dotted quad form (i.e., 192.168.10.253).
7-43
Chapter 7: BIOS