Table of Contents
Advertisement
Ranger™ Count 3000 Series
4.6 Print1 Menu
Enter this menu to set printing parameters. Default settings are in bold.
Note: The Print2 menu is only displayed if a second interface is installed.
Reset:
no, yes
Stable Only:
off, on
Auto Print:
off, on stable, interval, continuous, accept
Content:
P/N (-> off, on)
Result (-> off, on)
Gross (-> off, on)
Net (-> off, on)
Tare (-> off, on)
Header (-> off, on)
Footer (-> off, on)
Mode (-> off, on)
Unit (-> off, on)
Info (-> off, on)
APW (-> off, on)
Acc (-> off, result, all)
Layout:
Format (->S,M)
Feed (->Line, 4 Lines, form)
Data Transfer: off, on
Print Lib:
yes, no
End Print:
Exit menu
Reset [reset]
Reset the Print menu to factory defaults.
NO
= no reset
YES
= reset
Stable Only [Stable]
Set the printing criteria.
OFF
= values are printed immediately
ON
= values are only printed when the stability criteria are met
Auto Print [A.Print]
Set the automatic printing functionality.
OFF
ON.STAB
INTER
CONT
ACCEPT
Content [CONtNt]
Define the content of the printed data.
Part Number
Set the status.
OFF = disabled
ON
= enabled (The part or SKU number set up in Library will be printed)
Note: See section 3.7 for how to enter part or SKU number.
= disabled
= printing occurs each time the stability criteria are met
= printing occurs at the defined interval
= printing occurs continuously
= printing occurs each time the display is within the Checkweigh accept
range and stability criteria are met.
EN-19
Advertisement
Table of Contents
