Panasonic F-VR401 Operating Instructions Manual page 41

Symptom
It is difficult to install the tray to
the body.
The humidifying indicator blinks.
Even if the tray is not empty, the
humidifying indicator blinks.
The check indicator blinks.
Contact an authorized service center (as described in the warranty) immediately in the following case.
[ (Check)] indicator is lit
and all [Air Volume] indicators
are blinking.
Please confirm the following:
●
Is the humidifying filter or the filter frame installed properly? (P.35)
→ If they are installed incorrectly, it may be difficult to install / remove
the tray to/from the body.
●
Is the tray filled with water? (P.29)
Water is empty in "Humidifying clean air" mode.
If the tray is empty, the product will switch to "Clean air" mode.
→ To continue humidifying, fill the tray with water. (P.29)
●
Is the tray installed properly and completely?
●
Is the product inclined?
→ Place the product on the flat and stable platform or floor.
●
Is the product fell down?
→ Disconnect the power plug.
Raise the product. (Wipe off the spilled water.)
Leave the product more than half a day without operation.
(Dry the interior of the product completely, if water enters inside.)
Reconnect and turn on the product.
●
Has the product been shaken, inclined, or given impact?
→ Disconnect and connect the power plug again.
●
Has the magnet or any metal objects been placed on the product?
→ Disconnect and connect the power plug again.
●
Failure has occurred.
→ Disconnect the power plug and contact an authorized service
center (as described in the warranty) for a check or repair.
41
VR401