Table of Contents
Advertisement
Answering the baby monitor
Handset / Base unit
n When monitoring with a unit:
Handset: Press M
Base unit: Press M N to answer a call.
If you want to respond from the monitoring unit,
press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom feature
is set to "On" (page 27).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
MOFFN, then press M
– To answer the call with the base unit, press
*1
M N 3 times.
*1 If MMUTEN is pressed, press MZN 2 times.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature by
pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name of
each handset ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 47).
Handset
1
MMENUN#104
2
Enter the desired name (max. 10 characters).
3
MSAVEN a MOFFN
N to answer a call.
N.
Displaying the handset name
You can select whether or not the handset name
is displayed in standby mode. The default setting
is "Off".
Handset
1
MMENUN#105
2
MbN: Select the desired setting. a MSAVEN
a MOFFN
Changing the unit's region setting/
Resetting the base unit
1
MMENUN#136
2
MbN: Select the desired country. a MSELECTN
"Australia" = Australia
"New Zealand" = New Zealand
3
MbN: "Yes" a MSELECTN a MOFFN
Note:
R Changing the unit's region setting may cause
the settings for your country or your customised
settings to return to their default settings.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
R See page 4 for information on the available
model.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds.
Programming
47
Advertisement
Table of Contents
