Table of Contents
Advertisement
21. ADJUSTING THE POSITION OF THE WIPER (DDL-9000B-
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
❸
❹
❻
* When there is no need to use the wiper, set the wiper operation OFF according to the following procedure.
This setting can be made while the power is being turned ON. (One touch setting function.)
E
❼
❽
❾
❷
❶
1mm
F
❺
– 18 –
Adjust the position of the wiper ❻ according to the
thickness of the material sewn.
1)
Turn the handwheel in the normal direction of rota-
tion to align white marker dot ❶ on the handwheel
with marker dot ❷ on the machine arm.
2)
Adjust so that a clearance of 1 mm is provided
between the flat section of the wiper and the side
face of the needle. Tighten wiper adjust screw ❸
so that the wiper ❻ is pressed and fixed by wiper
collar ❹.
Keep pushing switch ❺ for 2 seconds. The display
1)
will change to the function setting mode.
2)
Change the setting No. E to
or switch ❽.
3)
Change the setting of F from "
switch ❾ or switch .
4)
In order to return to normal sewing state, push
switch ❺.
(Caution) When switch ❺ is pushed, the setting
made will be confirmed.
-WB, -0B)
using switch ❼
" to "
" using
Advertisement
Table of Contents
