Table of Contents
Advertisement
❻
❾
❽
❼
❹
❼
2.0 to 3.5 mm
Fit knee lifter pressing rod ❻. Fit hinge ❼ into the
6)
opening in the machine bed, and fit the machine
head to table rubber hinge ❽ before placing the
machine head on cushions ❾ on the four corners.
Securely attach head support rod to the table
7)
until it goes no further. Regarding the control
panel , remove two side plate fixing screws ,
place the rubber packing , which is one of the
accessories of the control panel , between the
head section and control panel , then fix them
together.
(Caution)
1. Do not use the screws supplied as accesso-
ries of control panel .
2. Be sure to mount the machine head support
rod on the machine table so that its height
from the table surface becomes 55 to 60 mm.
For the sewing machine provided with the AK
device, be sure to mount the support rod
on the table so that its height from the table
surface becomes 38 to 43 mm.
Bundle cable clip band supplied as accessories
8)
of the machine head at the root of the cable.
9)
Check to be sure that the table and the safety
switch arm are engaged with each other by 2.0
mm to 3.5 mm, with the sewing machine slightly
tilted.
(Caution) If the engagement between the table and
the safety switch arm is 2 mm or less, Error
302 may occur at the time of startup. Or, if the
aforementioned engagement is 3.5 mm or more,
safety switch arm may break.
10) If the engagement between the table and safety
switch arm is outside the range of 2.0 mm and
3.5 mm, loosen safety switch mounting screw
and tilt safety switch in the direction of the arrow
to adjust the engagement of safety switch arm
with the table.
– 3 –
Advertisement
Table of Contents
