Table of Contents
Advertisement
True Food International Equipment, Inc.
INSTALLATION OF CASTORS
IMPORTANT SAFEGUARD FOR INSTALLATION OF LEG/CASTOR (IMAGES 1-3 DEMONSTRATE PROCEDURE)
Securing Castors
To obtain maximum strength and stability of the unit,
it is important that you make sure each castor is secure.
The bearing race on the castor of the top edge of the leg
must make firm contact with the rail.
Unit leveling
Four leveling shims have been provided for leveling
castored units positioned on uneven floors. Shims must
be positioned between rail end and bearing race. TRUE
recommends a four shim limit to any single castor.
A. Turn the bearing race counter-clockwise until the
cabinet is level. Level front to back and side to side
(diagonally).
1
Thread castor into
the underside of cabinet
frame rail.
3
Use the tool provided to
tighten the castor into place.
5
INSTALLATION / OPERATION INSTRUCTIONS
2
For leveling, insert the shim
between the castor and
frame rail.
............ www.truemfg.com ............
B. Install the desired number of shims, making sure the
slot of the shim is in contact with the threaded stem
of the castor.
C. If more than one shim is used, turn the slot at a 90°
angle so they are not in line.
D. Turn the bearing race clockwise to tighten and secure
the castor by tightening the anchoring bolt with a 3/4
inch open-end wrench or the tool provided.
CAUTION
To avoid damage to lower rail assembly, slowly raise unit to
upright position.
Leveling Shim
Castor
Lower Rail Assembly
Rail End
Snug Fit
Here
Bearing
Race
5
Advertisement
Table of Contents
